DS Produkte TS-18439 Mode D'emploi page 19

12. Once the MAX marking of the dirty water tank (17) has been reached, switch off the
device by pressing the
the "After Use / Cleaning the Device and Accessories" chapter).
Then continue cleaning.
• Charge up the battery when the performance of the device diminishes (see the
"Charging Up the Battery" chapter).
19
6. Hold the device horizontally and pour the liquid from the
measuring cup (4) into the opening of the fresh water
tank (16). CAUTION: Do not pour more than 100 ml
(one full measuring cup (4)) into the fresh water
tank (16)!
7. Push the sealing cap (15) as far as it will go into the
opening of the fresh water tank (16).
8. Spray the surface which is to be cleaned: Hold the de-
vice vertically with the cleaning attachment (5) at the
top, direct the spray nozzle (14) towards the surface
and press the spray button (8).
9. Turn the device around, spread the liquid with the clean-
ing cloth (1) and dissolve the dirt.
10. Turn the device around again and switch on the suction
function: Press the
11. Hold the device by the handle (9), place the scraper
lip (20) on the wet surface and pull it up and down by
applying gentle pressure. Hold the device vertically and
do not press it on too fi rmly!
To prevent streaks from forming, do not allow
water residues to dry in the air.
Do not leave the suction function constantly
switched on so that the battery charge lasts for
as long as possible.
On/Off switch (7) and empty the dirty water tank (17) (see
On/Off switch (7).
EN