Operating Determinations; Installation; Operation - EuroLite Rubberlight RL1-230 Mode D'emploi

OPERATING DETERMINATIONS

This device is a lighting chain for creating decorative effects. This product is only allowed to be operated with
an alternating voltage of 230 V, 50 Hz.
The lighting chain is splash-proof (protection grade IP44) and can therefore be used inside and outside.
Do not shake the device. Avoid brute force when installing or operating the device.
The ambient temperature must always be between -5° C and +45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
This lighting chain must never be electrically connected with another chain.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

Unpack the lighting chain.
Unroll the tube, connect it with the mains and wait some minutes until it has warmed up. Disconnect from
mains and start with the installation.
In order to design the desired patterns, draw the form onto the surface and attach the mounting-clips. For
free forms, you can use a stable wire in order to bring the tube into the desired form. Use tie straps in order
to connect the tube with the wire. You can fix the tie straps with the suction cups.
The minimum bending radius is 3 cm.
The tube must never be shortened.
How to connect the tube to the power supply:
Connect the device to the mains with the power-plug. Make sure that the outlet is in a dry area.
How to connect a controller:
Connect the power cord with your controller.
After the installation, the power supply cable, the plug and the connector must be free of any tractive forces
and rotary forces.
The lighting chain must never be covered with any object.

OPERATION

After you connected the lighting chain to the mains, the lamps start burning.
10/19 00026665.DOC, Version 2.1