Assembly Instructions - Propane; Assembly Instructions - Natural Gas - AquaScape 58091 Mode D'emploi

Assembly Instructions – Propane
Installing the Batteries
• Remove back plate from the battery pack located at the bottom of the Auto-Ignite
Flame Control System and install 8 x AA batteries as shown (Ex. 1). Securely reinstall the
backplate, do not overtighten.
Locating the Propane Tank
• Place the propane tank a minimum of 60" (152.4 CM) away from the fire feature (Ex. 2).
Connecting the Flame Control System
• Aquascape fire features ship with a 10 ft/3 m gas hose and electric cable pre-attached to
the bottom of the burner system. Be sure to connect and lay out all components before
finalizing installation (see pg. 9 for details).
• Connect the opposite end of the gas hose to the 3/8" flare connection on the flame control system as shown (Ex. 2). After
making all connections, perform a leak test as described on page 12 of this manual.
NOTE: Do not use pipe compound or Teflon PTFE tape on flare gas connections.
• Connect the opposite end of the cable to the flame control system as shown, fully inserting before hand-tightening the
collar (Ex. 2).
Fire Feature
Connecting the Propane Tank
• Check to make sure there is no debris in the head of the propane tank or in the head of the regulator valve. Make sure you
check the burner and burner ports as well. Connect gas
line to tank by turning knob clockwise (hand tighten only)
(Ex. 3).
Disconnecting the Propane Tank
• Make sure the valve on the propane tank is closed.
Disconnect by turning the knob counterclockwise until it
is detached from the valve (Ex. 4).
10
Auto-Ignite Flame
Control System
Auto-Ignite
Power Cable
Rubber Gas Hose
☎
US (866) 877-6637 |
Prorpane Tank
Regulator & Hose
Minimum Distance to Tank
60" x 152.4 cm
Ex. 3
☎
CAN (866) 766-3426 | aquascapeinc.com
x 8 x 8
Ex. 1
Ex. 2
Ex. 4