Cosatto Giggle Trail Travel System Instructions page 8

Carrycot mode
Bumper bar
Carrycot apron
Raincover
Seat unit
Seat unit mode
Harness
5
19- NOTE: The carrycot can only be fitted rearward facing as shown in illustration.
20- Fitting:
Dots are marked on the seat mounts and carrycot mounts (a). These should be
on the same side and aligned if fitted correctly.
21- Removing:
NOTE: Please ensure that the bumper bar is securely fitted before lifting the
carrycot clear of the chassis.
22- Removing:
23- Removing the fabric cover for cleaning:
Refitting is a reversal of this procedure.
24- Fitting:
Removing is a reversal of this procedure.
25- Fitting:
Removing is a reversal of this procedure.
Preparation:
26-
Remove the bumper bar from the carrycot.
27-
Fit the bumper bar to the seat unit.
28-
Remove the hood from the carrycot.
29- Fit the hood to the seat unit.
30- NOTE: The seat unit can be fitted forward or rearward facing.
31- Fitting:
32- Removing:
33- Adjusting seat unit recline angle:
WARNING: Never adjust the seat unit with your child in the seat.
34- Opening:
35- Closing:
36- Adjusting the strap length:
Slide the strap adjustor to suitable length (a, b & c).
37-
Harness tension:
Always make sure that the harness is correctly tensioned to ensure maximum
protection for your child.
You should only be able to insert 2 fingers between the shoulder strap and waist strap.
NOTE: Winter/ Summer clothing can make a difference to the size of your child.
38- Adjusting the shoulder strap position:
39- Satisfactory shoulder strap position:
40- Removing:
Push the shoulder strap retainer through the backrest (a).
Push the crotch strap retainer through the seat (b).
Rotate the "C" clip to expose its opening (c) and slide the waist strap out of the clip (d).
Refitting is a reversal of this procedure.