Assembling The Stand - HOMCOM 824-012V90 Manuel D'utilisation

• Make sure that the device isn't dirty and that it is assembled
correctly
• Never operate the appliance on uneven surfaces or in the
vicinity of steps. Avoid tipping the device over when it is in
use (e.g. if there are borders on the floor).
• The pedestal fan may only be used, if it is fully assembled.
Check all screw / plug connections at regular intervals. Re-
tighten loose screws and ensure that plug connections are
properly adjusted.
OVERVIEW OF APPLIANCE
1. Air outlet grating
2. Holder
3. Time
4. Speed
5. Mode
6. Oscillation
7. ON/OFF
8. Power plug
9. Stand
10. Screws
11. Remote control

ASSEMBLING THE STAND

1. Take all of the appliance parts out of the packaging and remove all packaging
materials and inserts.
2. Turn the fan upside down so that you can look at the holder (2). (Fig.1).
3. Put the part.1 (Fig.2) of the stand (9) , and use 1 piece of screw to tight up,
see the methods by (Fig.3).