Télécharger Imprimer la page

Nikken PIMAG Optimiser Livret D'instructions page 5

Publicité

Les langues disponibles

Les langues disponibles

Important: Don't use detergent or soap to clean the pi ring, or expose it to water above 80°C.
Component replacement
You need to replace the pi ring regularly, which is
based on its age or the number of hours you have
used the Optimiser. The pi ring should be replaced
once a year or after 200 hours of use. See the
'Hours counter' section for instructions.
Trouble shooting
The Optimiser will not operate when the 'start/stop' button is pushed
• Check to make sure the Optimiser is plugged in.
• If your household power has been interrupted,
you might have to unplug the Optimiser and
The optimiser is running but the water is not moving in the jug
• Check to see the rotor is in the pi ring.
• Check to see the pi ring is properly locked into
the jug.
The Optimiser is making unusual noises
• Make sure there is enough water in the jug.
• Check to see if there are any foreign objects in
the jug.
The water does not taste good
• If you're using the Optimiser for the first time
(or haven't used it for a while), follow the
procedure described in the 'Before you use the
Optimiser for the first time' section.
The water is discoloured and has particles in it
• Make sure the pi ring is clean. See the cleaning
instructions in the 'Maintenance' section.
• If you're using the Optimiser for the first
time (or haven't used it for a while), water
Drinking and storing optimised water
You can save optimised PiMag
use it later, whilst maintaining its quality. You
®
Pimag
Optimiser specifications
Base:
Jug:
Weight:
Capacity:
Optimising cycle:
water so you can
®
5
When you're using the Optimiser, the rotor should
be moving with a rocking motion inside the pi ring.
If the rotor no longer makes a rocking motion, it
needs to be replaced.
plug it in again. Press the power 'On/Off'
then
button and press the 'Mode' and 'Start/Stop'
buttons again.
• Make sure the silicone rubber ring is placed
properly on the rotor.
• Make sure you use PiMag
Nikken PiMag
Water System.
®
discolouration may occur. See the cleaning
instructions for the unit in the 'Before you
use the Optimiser for the first time' section.
can refrigerate the optimised water as a way of
preserving freshness and taste.
22.5 x 14.5 x 33.5 cm
19 x 12.5 x 25.5 cm
2.1 kg
Two litres
Optimising cycle: 7 or 9 minutes
UK
water from the
®

Publicité

loading