Fill-Up And Start-Up Instructions; Filling The Spa With Water; Applying Power - lifeSMART ESTRELLA L Manuel D'utilisation

FILL-UP AND START-UP INSTRUCTIONS

The following procedures should be followed on initial startup and whenever the spa is drained for
routine maintenance.

FILLING THE SPA WITH WATER

1. Clear all the debris from your spa.
2. Be sure to open all jets to allow as much air as possible to escape from the plumbing during
the filling process.
3. Insert a garden hose into filter compartment to fill your spa.
NOTE: Do not use hot or softened water.
4. As the water level
rises, check inside
the equipment
compartment for
water leaks. It may
be necessary to
tighten unions
and/or fittings
that may have
loosened during
delivery. There is
no need to call for
service; this can
easily be done.
If assistance is
required, contact a Customer Service representative at (888) 961-7727 Ext. 8440
5. Under normal circumstances keep the water level half way between the top of the spa and the
top of the filter ring or just above the highest jets (whichever is higher).
Failure to keep enough water in your spa may result in damage to your system and invalidate your
warranty. If your spa filter is sucking in air causing the pump to cavitate, you need to add water!
6. Check the filter installation and make sure the filter is not loose.

APPLYING POWER

1. Turn power to spa "ON" (after filling spa) from the main panel at the house and the subpanel.
2. Press Jets button on the topside control panel to activate the spa. Rotate all the air control
valves clockwise and observe the increased jet action (air mixed with water). After several
minutes.
3. While the pump is running check again for water leaks at the drain spigot, unions, or fittings in
the equipment compartment (leaks may have occurred during transit). If water is leaking from
one of these areas, there is no need to call for service. Simply tighten the fitting. If assistance
is required, call a Customer Service representative at (888) 961-7727 Ext. 8440.
4. After checking your spa for leaks it is now time to adjust your spa settings. Press the
Plus or Minus button on your topside control panel until the display indicates your desired
temperature is set, after 5 seconds of non activity the control panel will display the actual water
temperature.
EQUIPMENT COMPARTMENT
15
UNIONS