Component Operation; Spa Component Operation - lifeSMART ESTRELLA L Manuel D'utilisation

SPA COMPONENT OPERATION

AIR CONTROL VALVE
The air control valves (smaller valves) serve to regulate the amount of air mixed with the water
when the jets are operational. Turn the air control valves in one direction to increased jet action.
Rotating the air control in the opposite direction to turn air off and allow the jets to work with water
only. Turn the air controls off when the spa is not in use, this will prevent cold air from entering the
spa and will keep heating cost to a minimum. The ozone jet, will always produce air bubbles when
pump is on.
HYDROTHERAPY JETS
The hydrotherapy jets are recessed in the wall of the spa. Rotate the large or medium jet faces to
turn the jets on or off. Turning a jet on or off will increase or decrease the effects of any jets not in
the closed position.
OZONE GENERATOR
The ozone system enhances the quality of the spa water when used to supplement the spa
owner's regular water maintenance program. Contrary to some information circulated throughout
the pool and spa industry regarding ozone systems, ozone CAN'T be used as a single-
source sanitizer, water clarifier, anti-foamer, and mineral chelating agent. A secondary source
sanitizer must be used to maintain 3.0 -5.0 ppm of Free Available Chlorine (FAC). LIFESMART
recommends that a chemical maintenance program based on recognized and documented
industry standards still be followed when using an ozone purification system to assure water
sanitation and the highest quality purified water.
WATERFALL
Your spa has a control valve to operate the amount of flow through the waterfall from no flow to a
steady stream. This valve is attached to the top and bottom of the waterfall. The waterfall will only
work when Jet Pump is on. Move valve side to side to turn on or off.
MUSIC (WHEN EQUIPPED)
You spa is equipped with a Bluetooth music sound system that requires a bluetooth device to pair
up with the the spa. To pair the spa and Bluetooth device:
• Go to the Bluetooth settings on you device and find in.stream 2 and press connect.
• Enter pin 5555 and press pair to sync your device. You are now ready to play audio from your
device.

COMPONENT OPERATION

14