EGAmaster 79000 Manuel D'instructions page 33

SAFETY INSTRUCTIONS FOR PREVENTION OF PROJECTILE HAZARDS
Wear impact-resistant safety goggles - This refers to the operator, as well as
for the persons within the vicinity of the machine. Assess and determine the grade
of protection required depending on the individual case. The risks to others should
also be assessed at this time.
On overhead work, wear a safety helmet - If a work piece, accessories,
inserted tools, or the tool itself breaks, there is danger from high velocity
projectiles.
• Before using the machine check all parts for damages.
• Replace damaged parts immediately.
• When working on brittle material make sure that you are protected against harmful splinters.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Only use machine tools, accessories and consumables, which are recommended by the
manufacturer. Make sure choosing the correct size and the correct type. Only use accessories,
which are in proper condition and do not touch them during operation.
WARNING – Injury due to carelessness.
ATTENTION – If the machine is fixed to suspension equipment make sure that
it is secure. Never hang the machine onto the supply line.
•
the machine tool or an accessory.
•
hot or sharp. Wear protective gloves!
Defective/ inappropriate gloves can lead to injury. Only wear proper hand
protection, adapted to the work place requirements.
WARNING – Explosion hazard!
When operating pneumatic impact wrenches in areas exposed to explosion
hazards, only use accessories, respectively devices, which are ATEX approved
and specified. Use low-sparking accessories.
SAFETY INSTRUCTIONS FOR PREVENTION OF TRANSPORT HAZARDS
CAUTION – Improper Transport, danger of life due to parts falling down!
Damage of the machine!
•
Separate the machine form any external energy source before changing
Avoid direct contact with the machine tool during and after use as it can be
Never carry the machine at the supply line.
33