Foppapedretti MEETING Manuel D'instructions page 17

11
12
ASSEMBLING THE PADDING
Place the padding on the seat.
Insert the plastic ring, fixed to the end of the strap, through the slots in the fabric and the corresponding slots in the seat shell.
Rotate the ring into a vertical position, on the outer side of the backrest. Check that it has locked correctly.
Insert the plastic ring, fixed to the end of the lap belt, through the slots in the fabric and the corresponding slots in the seat
shell.
Rotate the ring into a vertical position, on the outer side of the backrest. Check that it has locked correctly.
Insert the plastic ring, fixed to the end of the leg separator belt, through the slots in the fabric and the corresponding slots
in the seat shell.
Rotate the ring into a horizontal position, on the underneath of the backrest. Check that it has locked correctly.
13
• ENGLISH •
12
ASSEMBLY
CLOSING THE HIGH CHAIR (11)
TO CLOSE
CAUTION: Make sure that the child, and any other children, are at a safe distance away
when carrying out these steps. Make sure that the moving parts of the HIGH CHAIR do not
come into contact with the child's body during these steps.
CAUTION: If in use, remove the tray before closing by attaching it to the back of the frame
using the two hooks. See step 9.
Adjust the backrest and the leg rest to a vertical position.
To reduce its dimensions, we recommend that you adjust the seat to the lowest position;
see step 6.
Press the buttons located at the centre of the hinges on the leg frame and, at the same time,
using your foot to help you, close up the HIGH CHAIR legs (Fig. 11), until you hear a click to
indicate that they are locked in the closed position.
ASSEMBLING THE BASKET
Fasten the basket using the Velcro tabs, as shown.
MAX
3 kg
REMOVING THE PADDING FOR WASHING (12)
Rotate the plastic locking ring of the safety harness "straps"
and "lap belt" on the rear side of the backrest (a), and
remove the harness by pulling it from the inner side of the
seat, through the slots in the seat shell and padding.
Rotate the plastic locking ring of the leg separator on the
underneath of the seat and remove the belt by pulling it
from the inner side of the seat, through the slots in the seat
shell and padding.
Unclip the press stud that secures the fabric at the sides to
the armrest (b).
Remove the lining from the seat.
17