Calibration - SWAGTRON T8 Manuel D'utilisation

NOTE:
+ When riding at higher speeds, avoid turning too fast as this may result in accidents.
+ Avoid riding sideways or turning on slopes. The self-balancing sensors may malfunction and may require
recalibration.
+ Do not step on the center pivot point of the SWAGTRON
+ If the T8 flips over or rotates more than 180°, the motor and riding capability will be disabled. To restore
normal functionality, power off the unit, and then power it back on. After this, continue to ride as normal.

3.3 CALIBRATION

If your T8 seems to pull to the left or right during your ride, you may need to recalibrate its sensors. The process
requires a flat stable surface and a level. Levels may be purchased separately at most hardware stores or level apps
may be downloaded with most smartphones. To calibrate your unit, follow the instructions below.
STEP 1. Power off your T8.
STEP 2. Rotate the T8 until both pedals are level over the ground. For best results, use a level.
STEP 3. While the T8 remains level, press and hold the power button down to turn on the unit.
STEP 4. Keep holding the power button down for an additional 6 seconds. Release the power button when you hear
a single beep.
STEP 5. Press the power button again to turn the T8 off.
STEP 6. Press the power button again to turn on your newly calibrated T8.
English 14 SWAGTRON ® T8 Hoverboard
® .