Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Remove the handle side and top trims.
A
4. Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
A
5. Reinstall the handle-side and top trims.
6. Remove the protective skin from the screw covers. Slide or
snap the screw covers into the handle trim section.
7. Check refrigerator level and alignment. Adjust if needed.
24
A. Trims
A. Panels
A
Door Height Adjustment
Use the following steps to adjust the door height, up or down,
after the doors have been leveled.
1. Open the freezer or refrigerator door. Locate the bottom hinge
and remove the door stop screw.
Classic and Architect
Remove the door stop screw from the bottom side of the
hinge with a ³⁄₈" open end wrench.
Overlay Models
Remove the two door stop screws: one from the bottom side
using a ³⁄₈" open end wrench and one from the top side using
a ⁵⁄₃₂" Allen wrench.
A
2. Remove the locking plate as shown.
3. Turn the bushing located underneath the bottom of the hinge
using a ¹⁄₂" open end wrench. Turning the bushing to the left
(counterclockwise) will raise the door. Turning the bushing
right (clockwise) will lower the door.
Adjust Doors
®
Models
A
B
C
A. Bushing
B. Door stop screw
C. Locking plate
A
B
A. Door stop screw from bottom
B. Door stop screw from top (110°)
Publicité
Table des Matières
