Phoenix Gold Z8150V2 Mode D'emploi page 4

What should I do if the POWER STATUS LED turns RED?
If you observe that the POWER STATUS LED IS RED, please check the system
carefully to determine what has caused the protection circuit to engage.
To reset the amplified subwoofer when it is in PROTECT mode, turn the power off
to the system (usually by turning off the head unit or other signal source which
feeds the amplifier) and then turn it on again.
If the internal amplifier has shut down due to thermal overload, you should first
allow it to cool down before restarting.
If the shut down was due to either an input overload or a short circuit, be sure
to correct these conditions before attempting to power up the subwoofer
again.
MOUNTING THE SUBWOOFER
1. Find a suitable location in the
vehicle in which to mount the
amplifier. A typical location is
shown opposite.
2. Make sure there is sufficient air
circulation around the intended
mounting location.
3. Mark the location for the mounting hole screws by positioning the cabinet
where you wish to install it. Make a small mark to identify the position and
remove the unit.
Thoroughly clean the area you plan to attach the subwoofer, using a vacuum
cleaner.
© 2018 Phoenix Gold • www.phoenixgold.com
Z Series Slim Active Bass Enclosures
under vehicle seat