dirna Bergstrom bycool green line COMPACT 1.4 Instructions De Montage page 19

COMPACT 1.4
OUTSIDE CABIN:
3
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
Position the foam rubber, ensuring the softest
4
part is placed on the base of the unit.
Caution: Depending on the cabin, it may be
necessary to use the (2) supplied ducts in
order for the distribution panel to be completely
adjusted.
INSIDE CABIN:
5
Screw about 5 mm (4) 8/125x100 or 120 mm
studs, the exact measure is chosen after the
fastening supports have been presented and
taking into account that studs must stick out of
lower part about 20 mm.
IVECO Stralis since 2008: screw (4) studs
8/125x100 5 mm approximately.
Following this order:
6
• Ø 7 plane rubber wash
• Plane ruber wash wide wing diameter 8
• Nut M8
• Plane washer diameter 8 wide wing
4
Unit base
5
5
Plane ruber wash
Ø 7 plane
rubber wash wide wing Ø 8
6
19
®
Sun hatch
5 mm
Stud
Bracket
20 mm
Plane washer Ø8
Nut M8 wide wing
EN
3
5