Accessories - Kongskilde KDC 4000 Plus Manuel

Crop is not sufficiently cleansed
or sorted
Too much crop in the cleaners
waste outlet
The screens are not properly
cleaned by the cleaning brush-
es

Accessories:

Transport wheels and drawbar - part no. 131082033
Wheels and drawbar for transportation on rough ground
after a tractor. Use only over short distances. All local
traffic regulations must be observed - be especially
aware not drive too fast, to avoid any accidents!
Lifting arrangement for KDC4000 - part no.
131081850
For simple stepless adjustment of the inclination of the
cleaner by means of two longitudinal shafts, rotated by
crank at the inlet end. The lifting arrangement is stand-
ard on the KDC8000.
Incorrect screen holes combina-
tion selected.
Screen holes clogged.
Worn cleaning brushes.
Moist crop.
The capacity of the cleaner has
been exceeded / too much crop
is being supplied
The capacity of the cleaner has
been exceeded / too much crop
is being supplied.
Incorrect screen holes combina-
tion selected
Worn hair on the brushes.
Broken rubber bushes on the
brushes
Choose another screen combination.
Install cleaning brushes.
Replace cleaning brushes.
Add dry crop.
Add less crop
Add less crop.
Choose another screen combination
Replace the brushes
Cleaning brushes for the outer screens - part no.
131081810 (KDC4000) / 131082638 (KDC8000)
When using outer screens with small or oblong holes,
the outer screen can be clogged with impurities or ker-
nels blocking the perforation.
To clean the screens, it is advised to install cleaning
brushes.
The brushes are mounted on rollers, which rotate in the
opposite direction of the drum. For some outer screens,
the brushes do not cover the entire width of the per-
foration in the screen, which varies from one type of
screen to another (round holes, oblong holes or square
holes, and different dimensions). The perforation of the
outer screens varies in width due to the durability of the
screen and production technical conditions.
21