Secure Cap To Truck - Leer SUPER DUTY Notice D'installation

SECURE CAP TO TRUCK

Place clamp bolt with washer through J-Bolt pockets in cap.
Align J-Clamp as shown. Insert washer and nut, then tighten bolt.
Repeat at all (4) locations.
Tighten clamps to specifi ed torque
Adjust as necessary for proper fi t.
.
1. Insert the clamp bolt with large washer
through the holes in the cap sill. Slide the
clamp up from the bottom. Thread the nut
and smal washer onto the bolt.
2. Repeat in (4) locations.
3. Tighten clamps with a
Torque Wrench to
150 +/- 10 inch-lbs.
(12.5 +/- 0.8 foot-lbs.)
4. Clamps should be checked
and/or re-torqued periodically,
due to normal use.
5. Adjust as necessary for proper fi t.
Torque
Wrench
Scan For
5
Installation Videos