Table des Matières
Publicité
Installation and Operation 20/40/60 Minute Timers: 99-DET01 and 99-20M01
Operating your Lifestyle 20/40/60 Minute Fan Timer
Press and release the
speed override cycle. The
speed ventilation for the selected time. The
Light
run time. The
will flash during the last 5 min. of the cycle.
All timers connected to the unit will illuminate for the duration of the
Select Button
override when the
Lockout Mode
Lockout Mode is useful if you wish to disable the timers.
The timer can be set to lockout mode by pressing and holding the
Button
for five seconds. After 5 sec., the
lect Button.
The timer is now in lockout mode. If the
pressed during lockout mode the
override will be initiated.
If lockout mode is initiated when the timer is activated, the timer will
continue its timed sequence but will not allow any further overrides to be
initiated. Lockout mode can be unlocked by pressing and holding the
Button
for 5 sec. After 5 sec. the
Button
and the timer will now operate normally.
Plug Installation - 130ERV/130ERVR
The plugs are located in the ERV manual bag. The plugs will be installed into the 2 holes
located in the bottom tray of the ERV. They must be inserted from the inside of the unit to
ensure the holes are fully sealed, see detail below.
Foam Tray
Note
Ensure the plugs are firmly seated within the foam tray before operation.
Select Button
to activate a 20, 40 or 60 minute high
Light
will illuminate and the unit will run on high
is pressed.
Light
Light
will momentarily illuminate but no
Light
will stop flashing. Release the
Plug
Pre-punch hole
Light
will dim after 10 sec. for
will flash; release the
Select Button
Core
Plug
Pre-punch hole
Status
Lights
Select Button
initiates high
speed ventilation
for 20, 40 0r 60 min.
Select
Se-
Red #3
is
Yellow #4
Green #5
Select
Select
Foam Tray
Yellow
Red
Green
15
Publicité
Table des Matières
