Table des Matières
Publicité
Main Control Installation
The Lif estyle Digital Control 99-DX01 or Lifestyle Ventilation Control 99-BC01 may be
installed onto a flush mounted electrical switch box or it may be surface mounted onto a wall. Only
one master control should be installed to a ventilation system (the face plate on this illustration may
not be exactly the same as yours).
1. Remove the operating instructions card from the top of the control (Figure A).
2. Separate the face plate from the back plate by firmly pulling apart (Figure B). Be careful not to
damage face plate contacts pins.
3. Place the back plate of the control in the desired location on the wall and pencil mark the wall in
the center of the wire opening, top screw hole and bottom screw hole (Figure C).
4. Remove the back plate and drill a 3/8 in opening in the wall to allow for the wire opening and 1/8
in hole for the wall anchors for the top and bottom screw holes (Figure C).
5. Pull 3 wire 20 gauge (min.) 100 ft length (max.), through the opening in the wall and the wire
opening of the back plate (Figure C).
6. Connect red, green, and yellow to the wiring terminals located on the back plate (Figure C).
7. Secure a single wire to the wire
retainer located on the back
plate (Figure C).
8. Attach the back plate to the wall
using the 2 supplied screws and
anchors.
9. Attach the face plate to the back
plate (Figure B).
Note: Be careful to correctly
align the face plate to avoid
damaging the face plate
contact pins.
10. Insert the operating
instructions card into the
control (Figure A).
11. Connect the 3 wire 20 gauge
(min.) 100 ft length (max.) to
the terminal block located on
ventilator (Figure D).
Attention
Pay special attention not to damage the contact pins when removing and detaching the face plate (Figure B).
Operating
Instruction
Card
Figure A
Figure C
Face
Plate
Face
Plate
Contact
Pins
Figure B
Top screw hole
drill a 1/8 in hole
for the top screw
and anchor.
Wire opening
drill a 3/8 in hole
for the wire
Yellow #4
opening.
Green #5
Wire retainer
Wiring terminals
Bottom screw hole
drill a 1/8 in hole for
the bottom screw and
anchor.
Back
Plate
Dehumidistat
sensor openings
to room air allow
accurate sensor
readings, located
at top and
bottom of control
Red #3
Figure D
12
Publicité
Table des Matières
