Rimage Professional 5100N Mode D'emploi page 29

All manuals and user guides at all-guides.com
3. If necessary, perform a front to back alignment.
Turn the front to back
alignment screw until there is
a 1/16" (1.5 mm) gap between
the front edge of the disc and
the raised edge of the disc
retainer.
Tip: You can use the Torx
T25 driver or 5/32"Allen
wrench to turn the front to
back alignment screw.
4 Repeat steps 1-3 until the printer
is aligned.
5. When the printer is aligned, press the operator button to raise the lift arm up
about 1.0" (2.5 cm).
6. Exit diagnostic mode. Refer to the
page 23 for instructions.
2000447_E
Maintain the Professional
Printer Tray
Exit Diagnostic Test Mode
Front to Back
Alignment Screw
section on
26