Steelcase Empath Tablet Instructions page 2

®
4.
With the tablet arm in the upright position, locate the tablet surface on
the top plate of the tablet mechanism. Align the top plate holes with the
holes on the bottom of the surface.
5.
While supporting the tablet surface, install four (4) 10-24 flat head
fasteners using a 1/8" allen wrench. Torque all four (4) fasteners to 30 in-lb.
6.
Install the tablet cover by inserting the top (back) corner of the cover into
the arm pocket and sliding the corner up into position (6a) (Note: left side
facing tablet shown). Carefully flex the cover and rotate the bottom of the
cover down while tucking the edge into the arm pocket (6b). Carefully flex
and wrap the cover around the tablet mechanism and continue to tuck the
edge of the cover into the arm pocket working around the bottom cover up
to the opposite top corner of the cover (front of arm)(6c). Ensure that the
edge of the cover is tucked into the arm pocket and the cover snaps are
engaged on the tablet mechanism base. Installation video can be found
at: www. Steelcase.com/EmpathTabletInstall
6a
SLIDE UP
TABLET
COVER
6b
TUCK UNDER
4
TABLET
6c
WRAP AROUND
5
10-24 FLAT
HEAD FASTENER
TABLET SURFACE
ON TOP PLATE OF
TABLET MECHANISM
TABLET ARM
Page 2 of 4
24271101 Rev J