Horizon Global 76523 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Conical washer
teeth side
against hitch
Fasteners
typical
both sides
Figure 2
1. Remove tie down bracket: Using 14mm socket, remove (2) bolts from tie down bracket on rear passenger side of vehicle, as shown in Figure 2. Return bolts and
bracket to vehicle owner.
2. Install hitch: Raise hitch into position. Using 3/4" wrench and 3/4" socket, loosely install (2) 1/2" Bolts ①, (2) 1/2" Flat Washers ②, (2) 1/2" Conical washers ③,
and (2) 1/2" hex nuts ④ as shown in Figure 1, both sides. Using 17mm socket, loosely install (1) M10 bolt ⑤, and (1) 3/8" Conical washer ⑥ as shown in Figure
1, both sides. Note: If necessary, use wire brush to remove paint and debris from weldnuts.
3. Tighten all 1/2"-13 fasteners with torque wrench to 75 Ft.-Lb. (102 N*M).
Tighten all M10 fasteners with torque wrench to 42 Ft.-Lb. (57 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
© 2021 Horizon Global™ Corp. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76523, 84523, CQT76523
Existing weldnut
Figure 1
Frame rail
Sheet 3 of 12
Fastener Kit: 76523F
① Qty. (4) Bolt
1/2"-13 X 4.50 GR5
② Qty. (4) Flat Washer
1/2", 1.25OD
③ Qty. (4) Conical washer
1/2"
④ Qty. (4) Hex nut
1/2"-13 GR5
⑤ Qty. (2) Bolt
M10 x 1.25 - 35 GR8.8
⑥ Qty. (2) Conical Washer
3/8"
76523NP 08-30-21 Rev. A