Publicité
Les langues disponibles
Les langues disponibles
FOR YOUR SAFETY
Proper use
The e-screwdriver speedE
II is exclusively intended for fastening
®
and tightening metric screws in pre-drilled materials or to remove the
screws and loosen them. The electric screw fastening support makes
it easier to fasten screws. Only the slimBits made by the Manufacturer
may be used and the correct use of the screw head types must be
applied.
The LED lamp on the speedE
as a torch.
Improper use
Any use beyond and differing from the proper use is considered
improper use.
In particular, observe the following points:
•
Do not use the electric cut out on the engine as a torque tool.
•
Do not use the speedE
II for levering or chiselling.
®
•
Avoid impact on the end cap 1 .
•
Do not heat or deform the li-ion battery.
•
speedE
II is not suitable for continuous operation.
®
Residual risks
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious
injury. Save all warnings and instructions for future reference.
Work area safety
•
Keep work area clean and well lit. Cluttered or dark areas invite
accidents.
•
Do not operate power tools in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
•
Keep children and bystanders away while operating a power
tool. Distractions can cause you to lose control.
II can be used
®
Electrical safety
•
Power tool plugs must match the outlet. Never modify the
plug in any way. Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs and matching outlets
will reduce risk of electric shock.
•
Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators. There is
an increased risk of electric shock if your body is earthed or
grounded.
•
Do not expose power tools to rain or wet conditions. Water
entering a power tool will increase the risk of electric shock.
•
Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep cord away from
heat, oil, sharp edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
Personal safety
Stay alert, watch what you are doing and use common
•
sense when operating a power tool. Do not use a power tool
while you are tired or under the influence of drugs, alcohol
or medication. A moment of inattention while operating power
tools may result in serious personal injury.
•
Use personal protective equipment. Always wear eye
protection. Protective equipment such as a dust mask, non-skid
safety shoes, hard hat or hearing protection used for appropriate
conditions will reduce personal injuries.
•
Prevent unintentional starting. Ensure the switch is in the
off-position before connecting to power source and/or battery
pack, picking up or carrying the tool. Carrying power tools with
your finger on the switch or energising power tools that have the
switch on invites accidents.
ENG
15
Publicité
