Safety Notes - Westfalia 20 95 10 Mode D'emploi

Please note the included General Safety Notes and the following
safety notes to avoid malfunctions, damage or physical injury:

Make sure the voltage corresponds to the type label on the device.

Persons with limited physical, sensorial or mental abilities are not allowed to
use the unit, unless they are supervised and briefed for their safety by a
qualified person.

Keep the device out of the reach of children. It is not a toy.

Please read this manual carefully and use the device only according to this
manual.

The device may only be connected to a 230 V~ 50 Hz (10/16A) wall socket.

The unit is designed for operation in altitudes of up to 2000 m above sea
level.

Before undertaking any cleaning or maintenance work, pull the power plug!

Before connecting the device to the power mains, make sure the ON/OFF
switch is set to OFF. This avoids unintentional start-up of the device.

Please observe the instructions from the manufacturer of the polishing agent.

Do not turn the device on before it contacts the surface you intend to polish.

If you use an extension cord, please make sure that the cable is in good
condition and conforms to the demands in respect to power capacity.

Do not use the device in wet conditions or rain.

Do not wear loose-fitting clothing or jewellery; these may get caught by
moving parts.

Switch off the appliance and unplug form power supply before cleaning,
maintaining or when not in use. Do not pull on the power cable, but always on
the plug itself. Do not run the power cord over hot surfaces of around sharp
edges.

If the device or the power cord becomes damaged, do not use the device.

Do not disassemble the device and do not attempt to repair it yourself. It does
not contain any parts serviceable by you.

Safety Notes

3