Intended Use; Before First Use; Attaching The Bonnet - Westfalia 20 95 10 Mode D'emploi

Intended Use

The car polisher has been developed for private use and is not designed for the
demands of industrial use.
The polisher is designed for all types of polishing work with lambskins and
woolskins mounted on the pad holder.
The intended use also includes an operation following the operating instructions.
Any use beyond these parameters (different media, applying force) or any
changes (reconstruction, no original accessory) can lead to serious risks and is
regarded as use that is contrary to the intended purpose. The operator is liable for
any damage caused by improper use.

Before first Use

Remove the car polisher and all accessories for the packing. Keep packaging
materials out of the reach of children. There is a risk of suffocation!

Attaching the Bonnet

The device is shipped with two bonnets. The coarse bonnet is for applying the
polishing agent, the soft woollen bonnet is for buffing out the surface.
1. To attach the bonnet place the device with the pad holder on top on an even,
stable surface.
2. Now pull the bonnet over the pad holder. Please keep in mind that the bonnet
fits rather tight. The bonnet must be wrinkle-fee.
Please note: The foam on the pad holder can not be removed!
Operation
The dust developed when using some polishing agents may be a health hazard.
Because of this wear a dust mask and eye protection.
1. Attach the coarse bonnet to the pad holder.
2. Apply the polishing agent to the bonnet.
Spread it out evenly and observe the instruc-
tions of the manufacturer of the polishing
agent. Do not apply too much polishing
agent.
3. Bring the device down on the surface and
then switch it on.
4. Now move the machine evenly over the
surface. Do not apply downward pressure.
5. Before lifting the machine off the surface turn it off.
Hints
10