troubleshooting
warning:
under no circumstances should you try to repair the set yourself
as this will invalidate the guarantee. if a fault occurs, first check the points
listed, before taking the unit for repair. if you are unable to solve a problem
by following these hints, consult your dealer or service centre.
the cd player has no power, or playback does not start
• check that your batteries are not dead or empty, that they are inserted
correctly, that the contact pins are clean.
• your adapter connection may be loose. connect it securely.
• for in-car use, check that the car ignition is on. also check player's
batteries.
the indication
• check that the cd is clean and correctly inserted (label-side upward).
• if your lens has steamed up, wait a few minutes for this to clear.
the indication
• CD-RW (CD-R) was not recorded properly. use FINALIZE on your cd-
recorder.
the indication
• if hold is activated, then deactivate it.
• electrostatic discharge. disconnect power or remove batteries for a few
seconds.
the cd skips tracks
• the cd is damaged or dirty. replace or clean the cd.
• resume, shuffle is active. switch off whichever is on.
troubleshooting
no sound or bad sound quality.
• pause might be active. press 2;.
• loose, wrong or dirty connections. check and clean connections.
• volume might not be appropriately adjusted. adjust the volume.
• strong magnetic fields. check player's position and connections. also
keep away from active mobile phones.
• for in-car use, check that the cassette adapter is inserted correctly,
that the car cassette player's playback direction is correct (press
autoreverse to change), and that the cigarette lighter socket is clean.
allow time for temperature change.
IMPORTANT
modifications not authorized by the manufacturer may
void users authority to operate this device.
troubleshooting
is displayed
is displayed
is on and/or there is no reaction to controls