Sauder Edge Water 409044 Mode D'emploi page 8

Step 3
Diagram 1. Cut out and use the "spacer" at the top of this page to measure 2-1/2" from one end of the
å
INTERLOCK TRACK (Z). Position the INTERLOCK TRACK as shown.
ACTUATOR / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (Z) into the CABINET ACTUATOR (T).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to engage the second edge into the
å
CABINET ACTUATOR.
Diagram 4. Repeat the ACTUATOR / TRACK ATTACHMENT for the next CABINET ACTUATOR while
å
holding the previously completed CABINET ACTUATOR in its location hole. Repeat these steps until all
ACTUATORS have been attached.
Visually check that all INTERLOCK TRACK edges have been engaged into the CABINET ACTUATORS
å
as shown in diagram 3. Then, remove the INTERLOCK TRACK assembly from the END.
2
.
Page 8
Cut out this rectangle to use as a "spacer"
Z
A2
T
Z
T
2-1/2"
4
.
Do not slide the CABINET ACTUATORS
onto the INTERLOCK TRACK.
Z
3
.
409044
Z
1
.
T
T
www.sauder.com/services