Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INFORMATION
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation. Change or modifications not approved by the
party responsible for compliance could void the user's
authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
SPECIFICATION
Power requirement
U.S.A. and Canada
Other countries
Power consumption
Output
Charge
VTR
Charging system
Dimensions
Weight
: AC 120 V`, 60 Hz
: AC 110 V to 240 V`,
50/60 Hz
: 23 W
: DC 8.5 V
, 1.3 A
: DC 6.3 V
, 1.8 A
: Constant current,
peak detection,
timer controlled
: 140 (W) x 42 (H)
x 68 (D) mm (5-9/16"
x 1-11/16" x 2-11/16")
: Approx. 300 g (0.71 lbs)
EN-7
Publicité
Table des Matières
