Memphis PRO CART ITC 3 Guide De Démarrage Rapide page 2

HARDWARE COMPONENTS
Description/ Part No. Qty:
Picture:
1. VG0001Grate
1
Kit
2. Savorizer
1
VG4403
3. Direct Flame
1
Insert VG4407
4. Genie Tool
1
VG1595
5. Shelf Bolt
10
DS2311
6. Antenna
1
VG9023
7. #10 Screw
2
(SS) DS2186
8. Cord Wrap
1
VG0560
9. Meat Probe
1
VG0956
Packaging Locations
Savorizer
Left Shelf
Hardware Kit
Right Shelf
MEMPHIS PRO CART ASSEMBLY INSTRUCTIONS
1. Remove both shelves, the hardware kit, Savorizer, and grate
kit from the grill. The shelves are located in boxes underneath
the grill. The Savorizer and grate kit are in the grill hood. To
remove the Savorizer, cut the 4 zip ties holding it in place.
Remove all laser film on the grill. This is a peel-able plastic left
on to protect your grill from scratches during manufacturing and
transit. Remove all laser film and laser etch lines with WD40 or
olive oil. Once a grill has been heated up it is very difficult to
remove this film, be sure to check your grill thoroughly before
first burn.
2. Insert the Burnpot assembly into the slot inside the grill at the
bottom of the pellet chute.
3. Replace the Savorizer and place 3 large grates on the lower
level and the long grate on the upper level.
4. Remove the Direct Flame Insert and Genie Tool from the right
side shelf.
5. Install 2 shelf bolt (#5) into the right side of the grill. Leave
approximately 1/4" of the bolts sticking out so that the shelf can
slide onto them.
NOTE: ALWAYS HOLD SHELVES FROM THE BOTTOM AS THE
SHELF TOP SLIDES OPEN!
6. Slide the shelf onto the bolts, press down on the shelf to
secure into the keyway. Install the remaining 3 shelf bolts.
Tighten bolts using 3/8" wrench, socket, or adjustable wrench.
7. Repeat steps 5 and 6 for the left side of the grill.
8. Remove two 5mm socket head screws from Display Housing
shipping bracket using the 5mm allen wrench.
9. Snip the zip tie that secures the Display Housing to the
shipping bracket. Remove shipping bracket from Display
Housing. Short screws and shipping bracket can be disposed of.
10. Mount the Display Housing perpendicular to the side panel
over the Display Insert bracket using the two 5mm x 50mm
socket head screws in the hardware kit.
11. Attach the included antenna to the grill by twisting in a
clockwise motion. The antenna is included in the manuals.
12. Attach the cord wrap with included screws found in the
hardware kit.
COMPLETE THE STEPS BELOW IN NUMERICAL ORDER, REFERENCE THE SAME
NUMBERED DIAGRAM AND HARDWARE COMPONENTS FOR CLARIFICATION.
2
6
9
11
3
5
8
10
12