MSI H410M BOMBER Manuel D'instructions page 9

DIMM Slots
Please install the memory module into the DIMM slot as shown below.
1
⚠
Important
Always insert memory modules in the DIMMA1 slot first.
∙
To ensure system stability for Dual channel mode, memory modules must be of the
∙
same type, number and density.
Some memory modules may operate at a lower frequency than the marked value
∙
when overclocking due to the memory frequency operates dependent on its Serial
Presence Detect (SPD). Go to BIOS and find the DRAM Frequency to set the memory
frequency if you want to operate the memory at the marked or at a higher frequency.
∙ It is recommended to use a more efficient memory cooling system for full DIMMs
installation or overclocking.
The stability and compatibility of installed memory module depend on installed
∙
CPU and devices when overclocking.
∙ Please refer www.msi.com for more information on compatible memory.
M2_1~2: M.2 Slots
Please install the M.2 device into the M.2 slot as shown below.
3
Supplied
M.2 screw
1
Standoff
1
3
2
30º 30º
2
Overview of Components
2
3
9