Ultenic D7 Manuel De L'utilisateur page 15

�. Maintaining Sensors, Charging Contacts and Omnidirectional Wheel
Use a damp cloth to clean all sensors on the Robot.
Use a dry cloth to clean the
charging contacts on the Robot
(alcohol is not recommended).
Note:
Do not clean the omnidirectional wheel with water.
�. Maintaining Auto Empty Base
Auto Empty Base Dust Bag
The Auto Empty Base will remind you when the dust bag is full (Dust bag indicator "
smart LED display panel will be green). Discard of dust bag once full and replace dust bag with a
new one.
Open cover and pull
out the dust bag with
handle
Discard the used
dust bag
Remove any trapped hair or debris from
the omnidirectional wheel with the
cleaning brush provided.
Replace with new
dust bag & fully
lower cardboard
handle
" on the
Close cover