Oceanic FD-40MD Guide D'utilisation page 16

1. Insert the 3pcs tripod feet pipe (part 10) into the feet holder (part 9), And then the base
is ready for using.
Step-1
Insert the tripod feet pipe (3 pieces) into the holder,
reach the mark line of the of the pipe.
Step-2
Tight the screws on the feet holder, by doing so to let
the pipe don't loose.
2. Remove the nut and screws from the top of standing pipe. And then put the motor on
the top of the standing pipe, and tight the screws and nuts (part 5).
Step-1
Remove the thumb screw and axle from the upper end of
the standing pipe.
Step-2
Remove the screws from the motor unit bracket.
Installation