Cameo QUAD COLOUR LED PAR LIGHT Manuel D'utilisation page 11

COLOUR MACROS
In this mode, one of the 4 basic colours of the projector or one of the 11
different mixed colours can be selected as a preset.
Press the MODE button repeatedly until "CMXX" appears on the display. Now
press ENTER and then select one of the 15 colour presets using the UP and
DOWN buttons. Confirm with ENTER.
CM01 = Red
CM02 = Green
CM03 = Blue
CM04 = White
CM05 = Yellow
CM06 = Cyan
CM07 = Magenta
CM08 = Pink
COLOUR CHANGE
In the colour change mode (Jumping Mode), different colours are blended
into one another in succession. The speed of the program is adjustable
separately and a stroboscope effect can also be activated.
Press the MODE button repeatedly until "JXXX" appears in the display.
To adjust the speed of the colour change, press ENTER (the 2nd digit on the
display flashes) and then use the UP and DOWN buttons to select the desired
speed in the "JUXX" menu. Now, press ENTER again (the last two digits on
the display will flash) and using the UP and DOWN buttons, select the speed
with which the colours should alternate, from JU00 to JU99. Confirm with
ENTER.
To activate and adjust the strobe effect, press ENTER (the 2nd digit on the
display flashes) and then use the UP and DOWN buttons to select the desired
strobe effect in the "JFXX" menu. Now, press ENTER again (the last two
digits on the display will flash) and using the UP and DOWN buttons, select
the strobe speed JF00 to JF99 (JF00 = strobe effect deactivated, approx. 1
Hz = JF01, JF99 = approx. 20 Hz). Confirm with ENTER.
Colour change
Stroboscope
CM09 = Light Green
CM10 = Lavender
CM11 = Light Pink
CM12 = Light Yellow
CM13 = Light Magenta
CM14 = Light Cyan
CM15 = Warm White
Speed JU00 - JU99
Speed JF00 - JF99
OPERATION: OPERATION:
11