Teesa TSA3535 Manuel D'utilisation page 15

Owner's manual
3. Screw the blade holder into the jar. Make sure the blade holder is properly screwed on
the jar. Note that the water amount should not exceed the indicated maximum capacity of the jar.
4. Plug into power supply socket. Make sure the voltage indicated on this device
matches power supply voltage.
5. Place the blending jar on the motor body (with blade holder downside) and then
turn the blending jar clockwise into the motor base. Press the power switch, the blender starts
working. If the blending jar and the motor unit are not locked, the blender won't operate.
6. Do not run the juicer continuously for longer than 1 minute. Switch off and let it rest
for 2 minutes for the motor to cool down before starting again
7. After use, unplug the appliance from the mains. Spin out the jar counterclockwise.
8. Spin the jar lid out
Reminder: turn off the device when blending is complete. Do not run the device without any
food inside the unit as this could overheat the motor
15
EN