Sauder 411200 Mode D'emploi page 9

Step 5
Turn four BLACK 9/16" FLAT HEAD SCREWS (BB) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (N) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: If the MOLDINGS come up off of the SCREWS,
å
remove them and slide them on again.
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Shoulder
www.sauder.com/services
BB
Apply pressure with your hands as you
guide the MOLDINGS onto the ENDS.
N
B
N
411200
A
Page 9