Bench Grinder Assembly; Tool Rests; Eye Shields - Power Fist 8109670 Guide De L'utilisateur

8109217 manual 10/15/09
Switch
The switch is located on the
front of the grinder near the
bottom. To turn the tool
"ON" depress the top of the
rocker switch near the word
"ON". To turn the tool
"OFF" depress the bottom
portion of the rocker switch
near the word "OFF".
Installing the Tool Rests
TURN OFF AND UNPLUG
THE BENCH GRINDER
Install the tool rests on the
wheel guards using the bolts
and washers to secure them
in place as shown in Figure
1. The tool rest should be
adjusted to within 1/16" of
the grinding wheel or other
accessory being used.
Note: There is a left and
right tool rest.
Refer to Figure 1 to install
them correctly.
1:26 PM Page 6

Bench Grinder Assembly

Installing the Spark
Guards
TURN OFF AND UNPLUG
THE BENCH GRINDER
Install the spark guards to the
wheel guards using the two
smaller bolts and washers as
shown in Figure 2. Adjust
them to within 1/16" of the
grinding wheel or other
accessory being used.
Note: There is a left and
right spark guard. Refer to
Figure 2 to ensure that you
install them correctly.
Installing the Eye Shields
TURN OFF AND UNPLUG
THE BENCH GRINDER
Carefully examine Figure 3
and assemble one rod, one
bracket, one bolt and one flat
washer as shown. When it
has been assembled as shown
in Figure 3 install it on the
wheel guard of the grinder.
Position the mounting rod
above the grinding wheel as
shown in Figure 4 and
tighten the bolt securely.
After you have assembled
and installed each eye shield
mounting rod to the grinder,
attach the eye shields to the
rods as shown in Figure 5.
Install them in such a way
that the three hex nuts on
each eye shield are on the
back side away from the
operator when the tool is in
use. Tighten the center hex
nut so that the shield can be
adjusted but will be tight
enough to stay in place.
Always position the eye
shields between your eyes
and the grinding wheel or
other accessory being used.
Note: The eye shields are
identical and will fit properly
on either side of the grinder.
However, it may be
necessary to loosen the
center hex nut in order to slip
the shield over the mounting
rod.