Safety Instructions - CFM AXC Installation Et Entretien

ENGLISH
NOTICE
potentially explosive situation exists. Do not use where temperatures will exceed 140 F/60 C.
1. Ensure that the electrical service to the fan is locked in the "OFF" position. Do not re-establish
power supply until fan and activation device are completely installed.
2. AXC fans are not suitable for outdoor use.
3. This unit has rotating parts! Safety precautions must be exercised during installation, operation
and maintenance. Turn impeller by hand to make sure it rotates freely.
4. For general ventilation use only. Do not use to exhaust hazardous or explosive materials and
vapors.
5. To reduce the risk of fire, electric shock, or injury to persons — observe the following:
a. Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the factory.
b. A qualified person(s) must perform installation work and electrical wiring in accordance
with all applicable codes and standards, including fire-rated construction.
c. The combustion airflow needed for safe operation of fuel burning equipment may be
affected by this unit's operation. Follow the heating equipment manufacturer's guidelines
and safety standards as published by the National Fire Protection Association (NFPA), the
American Society of Heating, Refrigeration, and Air Conditioning Engineers (ASHRAE), and
local code authorities.
d. When cutting or drilling into walls or ceilings, take care not to damage electrical wires or
other hidden utilities.
e. Ducted fans must always be vented to the outdoors when used to exhaust moist/humid air.
6. Check voltage at the fan to see that it corresponds to the motor nameplate.
AXC fans are suitable for use with a standard on/off switch. Continental Fan also offers the following:
Part #
DT60
CT100V
DHS120V
VSC3
PLS120V
A spring operated backdraft damper (optional) is recommended to prevent the entry of cold air
into a bathroom through the exhaust duct. It should be installed just above the grille collar, and
may be mounted at any angle provided the damper blades are allowed to swing freely in the
airflow direction.

SAFETY INSTRUCTIONS

AXC in-line duct fans are not explosion proof and should not be used when a
Description
Digital Timer 10 – 20 – 30 – 60 Minutes
Spring Wound Timer 0 – 1 Hour
Dehumidistat
Variable Speed Control – 3 amp – 3 Wire
ON/OFF Switch w/Pilot Light
BACKDRAFT DAMPER
CONTROLS
2