Publicité
Les langues disponibles
Les langues disponibles
For Audi Q5
NOTE: for models without Fascia hitch access panel.
1.
Locate the central rib inside the bumper fascia. If center rib is not present, locate the centerline of the fascia, and mark a line.
From the top of the rib, measure down 6 1/4", then scribe a line 3 3/4"; approximately 1 7/8" to the left and right. The scribed line should be centered with the rib, as
2.
shown. NOTE: If center rib is not present, locate the top edge recessed area of fascia, measure down 6-1/4", and mark a line horizontally as shown below.
Using the newly scribed line as the bottom portion of a rectangle, scribe the remaining sides of a rectangle; 6 1/4" tall by 3 3/4" wide.
3.
4.
Cut out scribed section.
Top to bottom of section should be no greater than 6
¼". Width section should be no greater than 3 ¾".
For Porsche Macan
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
© 2014, 2016,
2017 Horizon Global™ Corp -
Fascia Trimming Instructions
CEQUENT
7.5''
For Macan S, and Macan Turbo, trim the fascia as shown.
For Macan GTS, trim as necessary
Printed in Mexico
top edge recessed area of fascia
Cut out scribed Section.
3.5''
4.0''
Sheet 3 of 9
75940N
10-2-17
Rev. E
Form: F205 Rev A 5-6-05
Publicité
