Maintenance / Recommendations; Electricity Supply - ims PRO COMBISPOT 230V Mode D'emploi

Translation of the original instructions

MAINTENANCE / RECOMMENDATIONS

• The operators must have received suitable training in order to use the machine at its maximum potential and
weld correctly.
• Check which welding process is authorised by the manufacturer before attempting any vehicle repair.
• The maintenance and the repair of the . Any work undertaken by a third party on the generator will invalidate the warranty. The
manufacturer will not accept liability in the event of an incident that would occur after this work was undertaken.
• Ensure the machine is unplugged from the mains, and wait for two minutes before carrying out maintenance work. Inside, voltages
and currents are high and dangerous.
• All the welding tools will wear off with use. Ensure that these tools are clean to get the best results.
• Prior to using the gun, check the condition of the different tools (star, single sided electrode, carbon electrode...) and clean or
replace if required.
• Remove regularly the casing and any excess of dust. Take this opportunity to have the electrical connections checked by a qualified
person, with an insulated tool.
• Regularly review the condition of the power cable and welding connection cables. In case of visible signs of damage, organise for
them to be replaced by the manufacturer or a qualified technician.
• Ensure the vents of the device are not blocked to allow adequate air circulation.

ELECTRICITY SUPPLY

Single phase supply 230V 50Hz. 16A Circuit breaker curve D 16 A aM.
NB: If the product trips the circuit breaker, please check that the correct fuse and an adequate circuit breaker are
being used.
• These are A-class devices. They are designed to be used in an industrial or professional environment. In a different
environment, it can be difficult to ensure electromagnetic compatibility, due to conducted disturbances as well as
radiation.
• From 1st December 2010, the new standard EN 60974-10 will be applicable: Warning: these materials do not com-
ply with IEC 61000-3-12. If they are to be connected to a low-voltage main supply, it is the responsibility of the user
to ensure they can be connected. If necessary consult the operator of your electrical distribution system.
Use of the aluminium generator: The COMBISPOT 230 protects itself if the voltage exceeds 265V. The device
prevents the charge of the capacitors. To indicate the failure, the 3 horizontal segments in the centre of the display
light up.
Charge of the capacitors: A blinking display indicates that the COMBISPOT 230 is charging the capacitors to the
setpoint. 'DEF' indicates that there is a capacitors charge fault. Switch off and relight the machine. If the message
persists, please contact after sales service department.
OPERATING AND SETTING (FIG I-II P.2)
SWITCH with 3 positions: Aluminium/OFF/Steel:
14
Alu
IMS COMBISPOT 230 V
Alu / Off / Steel
Steel
EN