aquabrass 1004 Manuel D'installation page 3

WATER TEMPERATURE ADJUSTMENT
If the temperature of the mixed
water is very different from the stan-
dard factory calibration at 100F
(38 o C), it may be necessary to
recalibrate the valve by following
these steps:
A. To calibrate the temperature, you
need to remove all the components of the
control handle up to the adapter (10).
Fig.7.
B. Open the shut-off valve (22) and
place a normal thermometer under the
water. Find the the ideal temperature at
100F (38 o C) by turning slowly the adapter
(10) (turning clockwise to reduce the tem-
perature). Fig.9.
C. Put back all the components shown in
step#4D (Fig.7). Align the red button of
the handle body (17) to the 100F posi-
tion indicated on the temperature stop (9).
CLEANING THE " CHECK-VALVE"
A. Remove all the components up to the adapter (10). Fig.10.
B. Shut off your main water supply in order to remove the check-
valve stops.
C. Unscrew the 2 check-valves (26) with ratchet and socket
(13mm). To clean the filters, you may need to soak in water and
vinegar to remove any calcium build-up. At the same time, check the
spring action in the check-valve to make sure it is operating freely.
Test with a small screwdriver.
D. Reverse the above for installation. Make sure your check-valve
stops are set in the open position.
Fig.10
Products info: www.aquabrass.com
TO SERVICE THE CARTRIDGE
A. Close the 2 check-valve stops(26) by turning them clockwise with
a screwdriver. Release the pressure of the remaining water by open-
ing the shut-off valve (22). Remove all the components until the
adapter (10). Remove the screw (11) and take out the adapter (10).
B. To service the cartridge (24), remove carefully with ratchet and
socket (32mm). You may need to soak in vinegar and water to
remove calcium build-up. If replacement is necessary, insert new
cartridge and reverse the above procedure. This should be your last
option.
C. To remove the cartridge of the shut-off valve (22), use a ratchet
and socket (17mm). Insert a new cartridge and tighten.
Before remounting all the finished trim, open the 2 check-valve stops
Fig.9
(26) with a screwdriver and follow step #4, #5 and #6.
Fig.11
TAKING CARE OF YOUR AQUABRASS PRODUCT
To clean your AQUABRASS faucet or accessory, wash with a wet non-
abrasive soapy cloth. Then wipe dry with a soft towel or cloth .We
recommend this be done on a regular basis.
DO NOT USE ANY ABRASIVE , CHEMICAL OR CORROSIVE, POWDER
OR ANY OTHER STRONG CLEANERS INCLUDING DETERGENTS, WIN-
DOW CLEANERS AND DISINFECTANTS ON YOUR AQUABRASS PROD-
UCT as they will destroy the finish and therefore VOID THE WARRAN-
TY. Toothpaste remnants should also be rinsed off when necessary.
Ask your plumbing retailer about our PROTECTANT-CLEANER now
available from AQUABRASS. This product is specially manufactured to
clean and polish leaving a protective coating to maintain your products
shine and finish.
1/2" thermostatic valve
#1004
Updated: 04-06-09