Operation - Kicker KMC2 Manuel D'utilisation

OPERATION

Playback
Use the MODE button to choose the input source for the KMC2:
Bluetooth, USB, AUX, and TUNER.
The KMC2 will automatically enter Bluetooth pairing mode when there
is no Bluetooth connection, with the display message "BT MUSIC".
When you begin scanning for devices on your audio device, the
KMC2 will identify as "Media Center".
The USB input source is only available when there is a USB device
connected. The KMC2 will automatically switch to USB input when
a USB device is connected and detected. KICKER recommends
SANDISK drives for the best performance. In testing, the KMC2 has
been shown to work with some HDD's, however, this is not supported
by KICKER! Drives must be formatted in FAT16 or FAT32 fi le systems.
Use the BND button to cycle through the 5 available radio tuner
bands: FM1, FM2, FM3, AM1 and AM2.
Settings
Press & Hold the MODE button to enter the settings menu. The
available settings are: Bass, Treble, Balance, Fader, Beep, EQ, Loud,
Area, and Preset Volume. Use the VOL - & VOL + buttons to change
the available values for each setting.
9
BEEP - select whether the KMC2 responds with beeps
EQ - select between EQ presets:
Flat, Classical, Pop, Rock, and Off
LOUD - select On or Off for a low frequency boost
AREA - select North America or Europe.
P-VOLUME - select the default volume level for the KMC2