Cleaning; Troubleshooting; Accessories; Repairs - Cibo Finit-Easy SMFE 2018 Manuel

Manual
Finit-Easy
Switching off: Press the rear end of the sliding
switch (7) and release the sliding switch.
9.

CLEANING

It is possible that particles deposit inside the
power tool during operation. This impairs the
cooling of the power tool. Conductive build-
up can impair the protective insulation of the
power tool and cause electrical hazards.
The power tool should be cleaned regularly,
often and thoroughly through all front and rear
air vents using a vacuum cleaner or by blowing
in dry air. Prior to this operation, separate the
power tool from the power source and wear
protective glasses and dust mask.

10. TROUBLESHOOTING

The electronic signal display (9) lights
up and the load speed decreases. There
is too much load on the machine! Run the
machine in idling until the electronics signal
indicator switches off.
The electronic signal display (9) flashes
and the machine does not start.
The restart protection is active. If the mains plug
is inserted with the machine switched on, or if
the power supply is restored following an inter-
ruption, the machine does not start up. Switch
the machine off and on again.

11. ACCESSORIES

Only use Cibo accessories. Only use accesso-
ries that comply with the requirements and
characteristics stated in this manual. Complete
accessories program, see www.cibo.be or the
catalog.

12. REPAIRS

Repairs to electrical tools must ONLY be
carried out by qualified electricians!
If the connection lead is damaged, it must
be replaced by a special connection lead.
Contact your local Cibo representative if you
have Cibo power tools requiring repairs. See
www.cibo.be for addresses.
13. ENVIRONMENTAL
PROTECTION
The generated grinding dust may contain harm-
ful substances. Do not dispose with household
trash; dispose of properly at a collection point
for hazardous waste.
Observe national regulations on environmental-
ly compatible disposal and on the recycling of
disused machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive
2002/96/EC relating to electrical and electronic
waste and implementation of national law, used
electrical tools must be collected separately and
disposed of in an environmentally friendly
manner at recycling centres.
EN
Finit-Easy Ι 33