Overview; Commissioning; Attaching The Safety Guard; Use - Cibo Finit-Easy SMFE 2018 Manuel

EN
6.

OVERVIEW

See page 2.
1 Clamping nut
2 Support flange
3 Spindle
4 Button for safety guard attachment
5 Safety cover
6 Spindle locking button
7 Sliding on/off switch
8 Handle
9 Electronic signal indicator
10 Speed adjustment wheel
11 Switch-on lock
7.

COMMISSIONING

Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the type plate match your power
supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.

7.1 Attaching the safety guard

Safety guard for grinding
Designed for work with unitized discs, roughing
wheels, flap sanding pads, cutting discs.
See illustration A on page 2.
• Place the safety guard (5) in the position
indicated.
• Push the button (4) and turn the safety guard
until the closed section is facing the operator.
• Release button and rotate guard until the
button latches.
(Disassemble in reverse order.)
32 Ι Finit-Easy
8.

USE

8.1 Adjusting the speed

Set the recommended speed at the thumb-
wheel (10). (small number = low speed; large
number = high speed)

8.2 Switching On and Off

Always guide the machine with both
hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw
in additional dust and shavings. When
switching the machine on and off, keep it
away from dust deposits. After switching off the
machine, only place it down when the motor
has come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from
the mains socket or if there has been a
power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
stand securely and concentrate.
0
Switching on: Push the sliding switch (7)
forward. For continuous activation, now tilt
downwards until it engages.
Manual
Finit-Easy
7
I