Connection Of The Power Supply Line - Videotec WAS Serie Manuel D'instructions

6.5 Connection of the board
6.5.1 Installing the fuse
Depending on the power supply voltage
choose the right fuse holder.
230V
FUS1
Fig. 6
The board is supplied with the fuse in the following
position: FUS1, 230Vac (6.4 Board description, page
4).
6.5.2 Connection of the power supply
line
The power supply cable should also be
covered by the silicone sheath (01) supplied
for this purpose. The silicone sheath must
be fastened with the corresponding tie (02).
Fig. 7
Remove the conductors protective sheathing and
connect them to terminal (board power supply, 6.4
Board description, page 4).
Use an external switch (minimum capacity
4A, 250V) to activate the pump.
MNVKWAS_1511_EN
120V 24V
FUS2 FUS3
01
02
Neutral (N)
Phase (L)
6.6 Connecting the pump motor
Operation valid for pump with 30m (98ft)
delivery.
Use the auxiliary terminal present in the waterproof
box of the pump (01). Connect the power supply
phase cable (L) and neutral cable (N). Connect the
earth cable to the pump casing (earth hole) (02).
Neutral (N)
Fig. 8
Use an external switch (minimum capacity
4A, 250V) to activate the pump.
Phase (L)
01
02
5