Troubleshooting Guide; Possible Cause(S); Corrective Action - Speedaire 45UZ55 Instructions D'utilisation Et Manuel De Pièces

TROUBLESHOOTING GUIDE

Symptom

Possible Cause(s)

1. Leakage a. O-ring / swivel seals are worn
b. Hose assembly is broken
2. Poor retraction a. The connected equipment is two heavy
b. Spring is fatigued after long-time used
c. The hose is not appropriated
3. Retracting too fast a. The spring is too tight
4. Not latched a. Incorrect operation
b. Latch assembly is worn
5. Electric power off a. Short circuit on the wire assembly
b. The terminal block does not connect
6. Electric leakage a. The wire insulation gets worn
b. The terminal block does not connect
MAINTENANCE
1. Make sure the cable is in proper working order and that the insulation is not cut or worn
as this could represent a hazard and jeopardize operation.
2. Clean the cable with a cloth dipped in warm water to remove dirt or deposits and ensure
correct rewinding.
3. Do not use detergents or solvents which could prove incompatible with cable-winder
materials.
4. If the event of having to perform maintenance on the electrical, mechanical parts or
replace the cable, contact an authorized after-sale service center.
5. Dismantling of the unit by unskilled personal could prove hazardous; the risk involved
mainly concern the preloaded springs.
well or worn out
well or worn out

Corrective Action

a. Replace the O-ring /seals
b. Replace the hose assembly
a. Intensify the spring force
b. Intensify the spring force or replace
spring canister if necessary
c. Replace with correct hose
a. Loose the spring tension
a. Reel latches on first, second or
third click. After the third click the
reel automatically rewinds.
b. Replace the latch assembly
a. Replace the wire assembly
b. Re-connect or replace the
terminal block
a. Replace the wire
b. Re-connect or replace the
terminal block
E5