2-Outlet Darkness-Sensing
Countdown Timer
Photocell Countdown Timer
2 grounded outlets and plug
18/3 AWG SJTW vinyl cord
Rated: 125VAC/60Hz/8A/1000W Resistive
8A/1000W Tungsten
INSTRUCTIONS:
Turn the dial to set:
OFF: Power to the outlets is off.
ON: Power to the outlets is on.
2HR, 4HR, 5HR, 6HR, 7HR, 8HR, 9HR, 10HR: Power
to the outlets is on and will shut off in the time chosen.
Time accuracy ±3%
Dusk/Dawn: Power to the outlets will come on when
it's dark and turn off when it gets light.
Plug the timer into the power outlet, the LED marked
with POWER will light up. The LED marked ON will
light up when power to the outlets is on.
NOTE:
This item is a photoelectric device and contains a light-
sensitive photocell to turn on and off automatically.
In order to operate properly, be sure to face the
photocell sensor on this device away from all nearby
light sources.
Timing devices require power to function properly. If
AC power to the timer is cut off, a light or other device
plugged into the timer will not work.
SAVE THESE INSTRUCTIONS!
Customer Service Assistance: Toll Free 1-855-350-6868
Hours of Operation: 10AM to 6PM, EST, Monday - Friday
Westinghouse and are trademarks of Westinghouse Electric Corporation and are used under license by The NCC. All rights reserved.
Manufactured and distributed by: The NCC Brooklyn, NY 11220 • www.thencc.com • © 2014 The NCC
WARNING:
When used outdoors this timer must be plugged
into a GFCI protected outlet to prevent shock hazard.
Let the switch hang downward so moisture doesn't
accumulate in the outlet. Install cord and unit above
ground level with the receptacle pointed downward
a minimum of 5ft. (1.5m) above ground. Suitable for
damp locations. Not for water immersion or for use
were directly exposed to water. Store indoors when
not in use.
CAUTION:
DO NOT splice, repair or modify. Unplug when not in
use. Fully insert plug. Inspect periodically. Use within
the electrical rating as the specification. DO NOT plug
more than a total 1,000 watts in this unit. If watts are
not marked on appliance, multiply ampere rating(on
nameplate) by 125 to determine equivalent watts. Add
determined watts for each plugged-in appliance or
lamp (sum of watts on bulbs) to find total watts being
used. Operating temperature range -30ºC (-22ºF) to
45ºC (113ºF).
Item #26436/28452/T26442
Model #28483
Made in China