Assembly - Troy-Bilt TB4BV EC Manuel De L'opérateur

WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing blower tubes, vacuum tubes or the vacuum bag.
ASSEMBLING THE UNIT AS A BLOWER
Installing the Upper Blower Tube
1. Align the bumps on the upper end of the upper blower tube with
the slots on the blower outlet (Fig. 1).
2. Insert the upper blower tube into the blower outlet (Fig. 1).
3. While holding the handle, twist the upper blower tube clockwise
until it locks into place (Fig. 1).
Installing the Lower Blower Tube
1. Align the bumps on the lower end of the upper blower tube with
the slots on the lower blower tube (Fig. 2).
2. Slide the lower blower tube onto the upper blower tube (Fig. 2).
3. While holding the upper blower tube, twist the lower blower tube
clockwise until it locks into place (Fig. 2).
ASSEMBLING THE UNIT AS A VACUUM
Removing the Upper Blower Tube
1. Insert a flat-head screwdriver into the tube lock. Turn the
screwdriver counterclockwise 1/4 turn and hold it in place (Fig. 3).
2. Twist the upper blower tube counterclockwise until it unlocks
from the blower outlet (Fig. 3).
3. Remove the upper blower tube from the blower outlet.
Removing the Lower Blower Tube
1. While holding the upper blower tube, twist the lower blower tube
counterclockwise until it unlocks from the upper blower tube.
2. Remove the lower blower tube from the upper blower tube.
Installing the Upper Vacuum Tube
1. Insert a flat-head screwdriver into the hole in the impeller door
and press the impeller door lock tab inward (Fig. 4). Open the
impeller door.
2. While holding the impeller door open, align the slots on the
upper vacuum tube with the tabs in the impeller intake (Fig. 5).
3. Insert the upper vacuum tube into the impeller intake (Fig. 6).
4. Twist the upper vacuum tube clockwise with both hands until it
locks into place (Fig. 6).
Installing the Lower Vacuum Tube
1. Align the arrow on the lower vacuum tube with the arrow on the
upper vacuum tube (Fig. 7).
2. Insert the lower vacuum tube into the upper vacuum tube (Fig. 7).
3. Twist the lower vacuum tube clockwise with both hands until it
locks into place (Fig. 7).
NOTE: When properly assembled, the dot on the lower vacuum
tube should align with the dot on the upper vacuum tube (Fig. 7).

ASSEMBLY

Bumps
Lower
Blower Tube
Tube Lock
Impeller
Door
6
Slots
Blower
Outlet
Upper Blower Tube
Fig. 1
Bumps
Slots
Fig. 2
Fig. 3
Fig. 4
Handle
Upper
Blower Tube
Impeller Door
Lock Tab