Kärcher BD 17/5 C Mode D'emploi page 11

6. Soak up the waste water with a wet vac-
uum cleaner or wipe it up with a cloth.
Shutting down
1. Set the power switch to "0".
2. Pull the mains plug out of the socket.
3. Clean the device with a moist cloth.
4. Wind the mains cable around the device
casing.
Illustration D
5. Secure the end of the cable with the ca-
ble clip.
6. Park the device in the parking position.
This prevents the brush from becoming
deformed.
Illustration E
Transport
CAUTION
Risk of injury, risk of damage
Be aware of the weight of the device during
transportation.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
Storage
CAUTION
Risk of injury and damage
Be aware of the weight of the device during
storage.
Care and service
WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the
socket before you start working on the de-
vice.
1. Wash dirty pads at a maximum of 60 °C.
2. Clean the casing of the device with a
damp cloth and then rub dry.
3. Check the mains cable for damage.
Troubleshooting guide
WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the socket
before you start working on the device.
In the event of malfunctions that cannot be rem-
edied using the following information, please
contact customer service.
Unsatisfactory cleaning results
 Replace the soiled pad and wash at a maxi-
mum of 60 °C.
 Replace a worn brush/pad.
 Check the suitability of the detergent used for
the application.
 Check the suitability of the brush/pad used
for the application.
The device vibrates strongly
 Check for central positioning of the pad on
the pad drive board.
 Check the attachment of the brush/pad.
The pad does not rotate
 Check if foreign objects are blocking the pad
drive board. Remove any foreign objects if
necessary.
 Plug the mains plug into the socket.
The warranty conditions issued by our relevant
sales company apply in all countries. We shall
remedy possible malfunctions on your appliance
within the warranty period free of cost, provided
that a material or manufacturing defect is the
cause. In a warranty case, please contact your
dealer (with the purchase receipt) or the next au-
thorised customer service site.
(See overleaf for the address)
Technical data
Device performance data
Voltage
Phase
Frequency
Power rating
Degree of protection
Pad
Pad diameter
Pad speed
English
Warranty
V
~
Hz
W
mm
1/min 0...450
BD 17/
5 C
220-
240
1
50-60
150
IPX4
160/
200
11