Good Earth Lighting SE1293-WH3-02LF0-G Instructions page 9

2
IMPORTANT
3
IMPORTANT
WHEN THE "AREA LIGHT" FEATURE IS ENABLED, IT WILL CONTINUE WITH THE SAME TIME
SETTING EACH NIGHT, UNTIL THE SETTINGS ARE CHANGED, OR THE FEATURE IS DISABLED.
Customize Settings (cont'd.)
SECURITY LIGHT (HIGH BEAM) TIME SETTINGS
To change the duration the light remains on after detecting motion,
rotate the "Minutes" dial to the preferred setting:
Test: ONLY use during initial set-up. "Test" allows the
motion detector to work during daylight hours to
fine-tune the PIR sensitivity.
1': Light will stay on for 1 minute after PIR detects motion.
2': Light will stay on for 2 minutes after PIR detects motion.
5': Light will stay on for 5 minutes after PIR detects motion.
10': Light will stay on for 10 minutes after PIR detects motion.
THE DIAL MUST BE ROTATED AWAY FROM THE TEST SETTING FOR THE
LIGHT ACTIVATION TO WORK PROPERLY. ROTATE THE DIAL TO A POINT
ANYWHERE BETWEEN THE 1' AND 10' SETTINGS AND THE LIGHT WILL ONLY
ACTIVATE DURING NIGHTTIME HOURS.
AREA LIGHT (LOW BEAM) TIME SETTINGS
The "Area Light" feature allows the installation area to be lit
during evening hours at a lower light level (~30% intensity of the
"Security Light" ) for longer periods of time. Activating the "Area
Light" will in no way cancel out or interfere with the activation of
the "Security Light."
OFF:
3hrs:
5hrs:
Dusk To The "Area Light" will activate at dusk and remain
Dawn : on until dawn.
THE "AREA LIGHT" CANNOT AND WILL NOT OVERRIDE THE
ACTIVATION OF THE "SECURITY LIGHT" OR ITS SETTINGS.
This completely disables the "Area Light."
The "Area Light" will activate at dusk for
3 hours, after which, it will automatically turn off.
The "Area Light" will activate at dusk for
5 hours, after which, it will automatically turn off.
9