Publicité
Step 6
Carefully turn your unit over onto its front edges.
å
Make equal margins along three edges of the BACK (I).
å
Push on the bottom edge of the RIGHT END and UPRIGHT
if needed to make it "square".
NOTE: The BACK should be against the bottom surface of
å
the TOP.
Fasten the BACK (I) to your unit using the NAILS (KK).
å
NAIL
(13 used in this step)
Page 10
I
KK
Edge without holes
411615
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
www.sauder.com/services
Publicité
