Publicité
Les langues disponibles
Les langues disponibles
5.
Determine the cover configuration for the installation.
6.
The cover support collar [4] may be oriented by removing and reinstalling four screws [5], see FIGURE B.
7.
Align and install vertical divider [6] as shown in FIGURE B. The notch on the vertical divider [6] should be on the
same side as the lap joint and corresponds to the 1 inch opening on the cover.
8.
Attach vertical divider [6] using hole [7], FIGURE B, and torque screw [8], FIGURE C, to 9-12 lbs -in (1.0 - 1.3 N m).
9.
Install top divider [9] with markings facing up. May need to tilt top divider [9] to install. See FIGURE D. CAUTION -
do not break off tab on divider, see FIGURE E.
10.
Slide top divider [9] so it rests on top of the mounting plate tab [10]. See FIGURE F. The mounting plate tab is not
visible from top view.
NOTCH
7
6
FIGURE
B
9
FIGURE
D
DO NOT
BREAK OFF TAB
LAP JOINT
5
4
FIGURE
OUTER HOLE
11.
Torque screw [8] to 9-12 lbs -in (1.0 - 1.3 N m). See FIGURE F. The outer hole must be used for installation, see
FIGURE E.
12.
Install second top divider [9] with markings facing down. May need to tilt top divider [9] to install. See FIGURE F.
CAUTION - do not break off tab on divider, see FIGURE E.
13.
Slide top divider [9] so it rests on top of the mounting plate tab [10]. See FIGURE F.
14.
Attach top divider [9] and torque screw [8] to 9-12 lbs -in (1.0 - 1.3 N m). See FIGURE G. The outer hole must be
used for installation, see FIGURE E.
15.
Refer to cover CFBS1R8FFCVR series installation instructions to complete cover installation.
9
9
8
6
C
6
INNER HOLE
FIGURE
E
8
LAP JOINT
10
FIGURE
F
8
FIGURE
G
Publicité
